Here you can also log out of your account. The settings menu allows you to choose some basic units of measurement. Pressing the identify pod button will cause the lights to flash in a rapid sequence so that the pod can be easily identified. Once you have selected a pod you can change who it is assigned to. To increase your range please see PlayerTek+ Multi App Live Data Here you are able to see all of your pods that are currently turned on. Please note that when in Indoor Mode these metrics are restricted to ones that do not rely on GPS signal. To learn more about each metrics please see Metrics Only certain metrics can be viewed during a live session. The metrics tab allow you to view live data from your PlayerTek+ pods. You can then change the name as well as the time period. To edit a split press the pencil icon on the right hand side of the screen. Here you are able to view and edit your splits. You can name you session and view the duration. Here you can begin and end a live session as well as creating splits. This is so that the splits that you created during the live session are synced up. Internet connection is required prior to syncing your pods.No internet connection is required to see the pods during a live session.Internet connection is required to login to the PlayerTek+ app.To view the data post-session you will still need to sync your pods. The data captured in this app is not stored so it is not available once the session has been ended. If you push and hold the power button and the 'no pods found' error still shows up, unplug the pod, turn it off and try the steps over again.The PlayerTek+ App is used by PlayerTek+ subscribers to view live data during a session, and to record a session in indoor mode. Unplug the pod and repeat the steps for any and all additional PlayerTek Pods. You'll notice if the pod is updated successfully, it will restart automatically and show up as a USB device in the computer. Wait for the green bar to fill up and for the Pods found to go back to 0. If this happens just disconnect it from the power and allow it to shutdown fully, then try again from step 1. If you get the timing wrong the pod will startup and enter USB mode. See below for a short video showing this process. *The middle light of the PlayerTek Pod should go solid once connected which indicates that the Pod is in firmware update mode. Press and hold the button until the left LED stops flashing (approx 30 seconds) or until "1 Pod Found" shows up in the PlayerTek Pod Updater. Watch the left green LED on the PlayerTek Pod flash 3 times. Push the PlayerTek Pod power button once to turn on the pod. You can do this using a single USB charging cradle, or using a docking case (up to 10 pods supported by the update tool).If the application fails to start your version of windows may need a Microsoft Update -please contact support and provide a screen shot of the error message. The pod updater should open like this below. Open the 'PLAYERTEK Pod Updater' from the extracted folder. Right click on the PLAYERTEK FW Update J3.20 folder and select -> Extract All -> Extract. Click on the attachment HERE to download the Firmware Installer.Make sure all pods are switched off and disconnected from power (laptop or docking case). Please run and install the Visual C++ package HERE and HERE (Please Run both).Please note - Windows 11 users should install windows 10 drivers. Please download the files and extract all the files. Please also install the relevant windows drivers, windows 7 users should use the win 7 drivers matching their operating system type 64/86. Please check what Windows version the PC is running - you can do this by typing about:Ĭlick into 'About your PC' and here it will show the System Type and Windows version: The PlayerTek Firmware updater can enable pods to be used for live tracking with the PlayerTek+ Live App, Indoor mode and the best version for Heart Rate data with compatible straps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |